Results 41 to 44 of 44
Thread: Consultant's New Build - project thread (help needed)
-
07-27-09, 10:47 AM #41
Re: Consultant's New Build - project thread (help needed)
Originally Posted by Consultant
Have you clicked on the little speaker icon in your system tray and picked a default audio out? It might depend on your soundcard and OS, but in some cases you have to tell it you are using the front port.
-
07-27-09, 10:51 AM #42
Re: Consultant's New Build - project thread (help needed)
Also you mentioned that it was set to HD Audio in bios. There are two audio types using the same connector if it's like my card and you might just have it enabled as the wrong type.
Krakkens and shit. stop tempting them. -- Bigdog
-
07-27-09, 11:47 AM #43
Re: Consultant's New Build - project thread (help needed)
Originally Posted by Kanati8869
And in the ACL1200 settings panel it shows which jacks have stuff plugged into them and the front jacks show as empty even if there are plugs in them. It's like the computer doesnt even know they are there.
-
07-27-09, 12:24 PM #44
Re: Consultant's New Build - project thread (help needed)
Well the 300 has connectors for both AC97 and HDA. So... Make sure you have the HDA plug hooked to the motherboard. Make sure the bios has HD Audio chosen in advanced settings and that High Definition Audio is enabled as well... And that you have SPDIF checked for SPDIF mode setting and not HDMI...
Other than that, that's all you should have to do.
Krakkens and shit. stop tempting them. -- Bigdog
Thread Information
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
Bookmarks